July 15

Good News

News

0  comments

My luggage has been found. I will have all the equipment I need for my class tomorrow.  However, in the process of preparing to do the class without the items lost, I had a few difficulties.  I am using a box with a hole in it and putting a foam noodle in the hole to model the tuning pin.  I lost the noodle so I had to get another. The new one is too small so I had to rip out the cardboard cylinder and insert a smaller cylinder for the smaller pin. This was quite difficult as I am used to repinning with larger pins! Also, I am modelling the string's effect by attaching elastic cord to the box.  I lost the cord, so I tried elastics. Seems elastics do not hold their elasticity very well. Plus they kept breaking. However, they are much easier to splice than real strings.  Due to them loosing elasticity, I decided to go stronger. I could only find bungee cords. Seems they were too strong and the table I was using to tie one end to, collapsed.      About 33 1/2 hours of anguish finally come to an end.  Let's just hope nothing's damaged! :-0 Air Canada did say they would give me $50. :-)

About the author 

Mark Cerisano, RPT, B.Sc.(Mech.Eng.)

Instructor and Founder, howtotunepianos.com

You may also like

Setting F3-A3

Beginning technicians are often advised to initially set F3-A3 to 7 beats per second (bps). Mathematically F3-A3 = 6.9 bps in equal temperament so it’s a good guess.After using the skeleton or contiguous M3’s also known as Jack’s Stack, we can refine F3-A3 to be more what the piano needs, but 7 bps is a

Read More

How to Regulate a Piano!

I often read questions on piano technician forums from technicians asking how to regulate a specific piano. For example, recently someone posted this.“I’m regulating a piano and the book says to regulate blow distance at 1.5 inches”or“I can’t find any regulation specs for this specific piano in any books” The writing of these books implies

Read More

Analysis of a Unison – Before and After

When a string is played, it vibrates in different modes. It can vibrate in one section, two sections, three sections, etc. These modes are called partials or harmonics. The following graphic shows how the harmonics relate above the note A4.When two or more strings are tuned together, all of their partials must have the same frequency

Read More