New Lesson Posted: How to Tune Beatless Octaves

"Beatless" is a term I, and other technicians, like to use to describe an octave that sounds like a beatless unison. It just means that it sounds pure and has as little motion in the upper partials as possible. I have created a flow chart that shows you how to measure the inharmonicity of a piano aurally and then tune the best octave for that piano. You can read the lesson HERE

About the author 

Mark Cerisano, RPT, B.Sc.(Mech.Eng.)

Instructor and Founder, howtotunepianos.com

You may also like

Setting F3-A3

Beginning technicians are often advised to initially set F3-A3 to 7 beats per second (bps). Mathematically F3-A3 = 6.9 bps in equal temperament so it’s a good guess.After using the skeleton or contiguous M3’s also known as Jack’s Stack, we can refine F3-A3 to be more what the piano needs, but 7 bps is a

Read More

---

How to Regulate a Piano!

I often read questions on piano technician forums from technicians asking how to regulate a specific piano. For example, recently someone posted this.“I’m regulating a piano and the book says to regulate blow distance at 1.5 inches”or“I can’t find any regulation specs for this specific piano in any books” The writing of these books implies

Read More

---

Analysis of a Unison – Before and After

When a string is played, it vibrates in different modes. It can vibrate in one section, two sections, three sections, etc. These modes are called partials or harmonics. The following graphic shows how the harmonics relate above the note A4.When two or more strings are tuned together, all of their partials must have the same frequency

Read More

---